DESIGNING  IS OUR  GAME

KU300 BUCKET WHEEL EXCAVATOR RECONSTRUCTION STUDY - NOEN, a.s.

General description

Based on the requirement of Severočeské doly a.s., NOEN, a.s. drew up the KU300 bucket wheel excavator reconstruction study aimed at modernization, an increase in reliability, and time utilization during mining procedures. The basic concept of the KU300 bucket wheel excavator reconstruction involved replacement of the extensible bucket wheel boom with a non-extensible type and replacement of the suspended loading boom with a newly designed loading boom. The maximum impact on technical parameters resulted from requirements for the driving station dead space length of 65 m, the possibility of mining in two blocks with one position of the belt conveyor DPD with total width of 55 m and deep cut of 10 m.

Main parameters

Parameter Value Unit
Lining of bucket wheel from excavator axis (horizontally) 26 m
Bucket wheel diameter 7.5 m
Number of buckets 13
Installed power of bucket wheel drive 500 kW
Nominal speed of bucket wheel – 1st speed 7.16 1/min
                                         – 2nd speed 8.16 1/min
Range of bucket wheel speed control 50÷120 %
Width of conveyor belt 1,400 mm
Belt speed 4.1 m/s
Adjusted longitudinal slope of excavator 1 : 9
Adjusted longitudinal slope of supporting car 1 : 9
Permissible general tilt of excavator and supporting car 1 : 20
Length of connecting bridge 65 m
Length of connecting bridge retraction 16 m
Length of discharge boom 14 m
Slewing range of superstructure related to transfer boom ± 100 º
Slewing range of connecting bridge related to transfer boom ± 90 º
Slewing range of connecting bridge related to supporting car ± 90 º
Width of block (in two advances) 55 m
Height of the 1st high cut 18 m
           the 2nd high cut 9 m
           low cut 10 m

Back


Contact us If you are interested in co-operation or delivery of machinery, please contact us.